Bose X 소유자 매뉴얼 - 페이지 24
{카테고리_이름} Bose X에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose X 36 페이지. Installation of headset into cloth/leather helmet
Bose X에 대해서도 마찬가지입니다: 설치 (4 페이지)
페이지 인쇄
U
Y
H
SING
OUR
EADSET
24
CAUTION: Avoid setting the volume levels too high. Exposure to
loud sounds may cause hearing damage.
Notice the individual earcup controls
Separate knobs on the control module control the volume for each
separate earcup (Figure 19 on page 23).
Holding the control module upright and facing you:
• Use the left knob to adjust volume in the left earcup.
• Use the right knob to adjust the volume in the right earcup.
Controlling the volume of a single aircraft powered headset
With ANR turned on:
1. Set the aircraft communication system to a safe operating level.
Note: If you are connecting the headset to your aircraft for the first
time, turn down the master output level of your radio/intercom system
to avoid exposure to high volume levels.
2. Turn each volume knob on the headset control module down to
decrease, or up to increase the volume of the earcup it controls.
Volume control using multiple headsets
When an aircraft has more than one headset connected to its audio
system, the pilot in command should adjust the volume of his/her
Bose Aviation Headset
1. Turn off ANR by setting the power switch to OFF.
2. Turn up each volume knob on the headset control module to its
maximum.
3. Adjust the master volume on your aircraft intercom or radio until
you can hear communications clearly.
Note: This should be done in a noisy environment.
4. Adjust the knobs on the headset control module to balance the
volume between the left and right earcups.
5. Turn ANR back ON.
6. Reduce the master volume on the aircraft intercom or radio to
the level you prefer.
After the pilot's headset volume is set, passengers may adjust the
volume of their headsets. Have them follow steps 1 and 2 under
"Controlling the volume of a single aircraft powered headset" above.
as follows: