Drolet The Hunter 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Drolet The Hunter에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drolet The Hunter 11 페이지. Wood heater and cook stove
Drolet The Hunter에 대해서도 마찬가지입니다: 소유자 매뉴얼 (9 페이지)

페이지 인쇄

Before igniting the paper and kindling wood, it is recommended that you warm up the

chimney. This is done in order to avoid back draft problems; cold air from the outside tends

to penetrate into the chimney. Twist together a few sheets of newspaper into a torch. Light

up this paper torch and hold it as close as possible to the entry of the flue inside the

combustion chamber to warm up the chimney. Once the updraft movement is initiated, you

are ready to ignite the stove by lighting the paper and kindling wood inside the combustion

chamber.

Leave the door slightly opened (a few inches) for a 5 to 10 minute period, under

supervision, in order to allow for good combustion. After this time, you may close the door

and progressively adjust the air control to obtain the desired intensity.

CAUTION:

Do not leave the stove unattended when the door is slightly opened.

When the stove is used for the first time, intense fire is prohibited in order to allow

adequate curing of the paint covering the stove and to prevent a "thermal shock"

which may remove or whiten the paint.

Make sure the area where the stove is located is well ventilated, to remove the bad

odors emitted from the paint, during the first, two or three hours of using the stove and

for the first three or four fire start-ups.

Never use chemical liquids to ignite the fire.

Do not burn waste, flammable fluids such as gasoline, naphtha or motor oil.

Using your HUNTER:

Once you have obtained a good bed of embers, you should reload the unit. For optimal and

safe operation, we recommend that you operate the stove with a wood load not higher than 6

inches.

The combustion air intake control is located on the door. We strongly recommend that you

install a magnetic thermometer on your smoke exhaust pipe, approximately 18" (457 mm)

above the stove. This thermometer will indicate the temperature of your gas exhaust fumes

within the smoke exhaust system.

The ideal temperature of the flue is between 250 F and 500 F. Below this temperature, the

build-up of creosote is promoted while above 500 F (260oC), heat is wasted.