AirTek MOB-10KDCHR 사용 설명서 및 사용 - 페이지 15
{카테고리_이름} AirTek MOB-10KDCHR에 대한 사용 설명서 및 사용을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTek MOB-10KDCHR 20 페이지. Mobile air conditioner
페이지 인쇄
Drainage
When the product is in cooling mode, dehumidification will be performed
simultaneously, during this process water will be accumulated inside the product.
When the water reaches the preset level, the compressor will stop and only the fan
will operate. The Alarm indicator("
begin to beep ) turns on, the air conditioner switches itself off. To reset the unit for
normal operation, drain the water using one of the following methods:
(1) Drain Tray
1. Turn off the unit when the Alarm indicator turns on.
2. Position the supplied drain tray flat on the floor, beneath the drain hole.
Remove the drain cap and rubber plug from the drain hole, allowing the water to
3.
drain out to the drain tray.
4. When the drain tray is almost full, put the rubber plug back to the drain hole and
empty the tray.
5. Repeat the above procedures if required.
RUN" LED LIGHT
start to flash, the unit will
15