247Blinds Plantation Shutter 피팅 지침 매뉴얼 - 페이지 4

{카테고리_이름} 247Blinds Plantation Shutter에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 247Blinds Plantation Shutter 7 페이지.

For Tier on Tier ONLY:

3) Tier on Tier shutters come with a T-post.

These are 50mm as standard. This will

come as one piece, as we do not offer

this a configurable option.

You should insert this in the frame using

the pre-drilled holes. Once assembled,

lift the frame into position.

Note: Small single panel Shutters can

arrive within a fully assembled frame.

You should remove the panel and any

frame cover strips in order to access the

pre-drilled fixing holes in the frame.

This is where a spirit level become useful, use packing as you go along as required.

1) Next mark the top screw holes on the right and left

sides of the frame by screwing the top screws

partially into the wall and then unscrewing them.

Once you have marked these two screw holes, push

the frame away, drill the holes and insert your wall

plug.

2) Bring back the frame, and screw the two top screws

part way into the holes. This will hold the frame in

place and allow you to make adjustments to the

position.

3) Note that drill holes are not always pre-drilled into the frames, this is to allow you to fit the

blinds as you require. Do not use all the screws, do not fully fix the frame until all the

panels have been hung, as this allows any adjustments.

247blinds.co.uk

Reviewed 06/12/2021

Next Review: 06/12/2023

Fitting the Frame