Drolo Moon Rabbit 매뉴얼 - 페이지 4

{카테고리_이름} Drolo Moon Rabbit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drolo Moon Rabbit 6 페이지. Phaser

env/0/exp

These 2 toggle switches define how the envelope follower and expression input are controlling rate

and range respectively (follow the little black arrow to see what switch controls what parameter)

- Set to 0, only the respective knob is active. Exp and envelope have no effect on the given parameter.

- Set to exp, the parameter will be controlled by the expression input. In this scenario the actual knob

(rate or range) serves to scale the range of the expression input. (setting its maximum value)

- Set to env, the chosen parameter will receive the signal from the envelope follower. Again here, the

actual knob serves to scale the effect of the envelope signal. (setting its maximum value)

EXP input

Can be used to externally control the rate or range. When an expression pedal is connected, the rate

pot can be used to define the max setting of the expression pedal.

Most commercially available expression pedals based on a potentiometer and using a TRS plug

should work. The value is not really critical, although I would not go lower than 10k.

Some examples are the Moog EP-2, Roland EV-5, and M-Audio EX-P.

You need to use TRS (Stereo) plugs and cables. NO MONO PLUGS OR CABLES! These will short

out the voltage regulators inside the pedal and damage it.

If you really know what you are doing you can actually use a control voltage instead of a

resistance based controller. But you need to consider the connections and never exceed 5V. If

you do you might damage the pedal. Use a TRS plug. No Mono plug. TRS, NOT mono :)

If you have any doubt when deciding what to connect to the expression input please send me

an email and I will verify that everything is safe.

Here is how such a TRS plug looks like.

The exp jack is connected to the pedal like this:

sleeve : ground

ring: 5V supply voltage

tip: controlling (varying) pin