Dromida SC 4.18 BL 매뉴얼 - 페이지 3

{카테고리_이름} Dromida SC 4.18 BL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dromida SC 4.18 BL 4 페이지. Radio controlled truck

DRIVING THE VEHICLE

1. Install the battery into the vehicle and

connect the battery.

2. Secure battery strap to post using clips.

Brake/

Reverse

Forward

Neutral

• To slowly drive forward, pull the trigger slightly. To drive faster,

pull the trigger further.

• To brake, push the trigger. To drive in reverse, push again.

• During a crash, release the trigger.

• When the vehicle battery becomes low, the vehicle will start to slow down.

• Allow the battery to cool before recharging.

• Make sure to turn both the vehicle and the radio off after each use.

• ALWAYS unplug the battery after each use.

Throttle Dual Rate

• If you need to limit the maximum speed of your vehicle, rotate the "TH.D/R" knob

counterclockwise. For higher top speeds, rotate the knob clockwise.

Steering Dual Rate

• If you need to limit the amount of steering your vehicle has, rotate the "ST.D/R" knob

counterclockwise. For more steering, rotate the knob clockwise.

NOTE: We recommend limiting the vehicle's maximum speed for beginners and gradually

increasing the top speed once you become more comfortable with the controls.

DRIVING TIPS

• Always release the throttle trigger right away following a crash to prevent damaging the electronics.

• The vehicle should be operated in an open space with no people or animals nearby.

• Do not operate this vehicle on the street.

3. Switch radio on.

Forward

Reverse

• To turn, rotate the wheel to the left or right.

• Adjust the steering trim if the car doesn't track straight (see

Throttle Trim

• If the vehicle rolls forward without throttle input, rotate the throttle trim knob slightly left.

• If the vehicle rolls backwards without throttle input, rotate the throttle trim knob slightly right.

Steering Trim

• If the vehicle tracks right (when viewed from behind), rotate the steering trim knob slightly left.

• If the vehicle tracks left (when viewed from behind), rotate the steering trim knob slightly right.

• Check that the servo saver screw is fully tightened to ensure that your vehicle tracks straight.

4. Switch vehicle on.

Left

Right

below).

Right