Dromida DIDC01000 지침 - 페이지 2

{카테고리_이름} Dromida DIDC01000에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dromida DIDC01000 4 페이지. 1/18 mt/sct 4wd rtr

VEHICLE AND RADIO PARTS
M370 Motor
On/Off Switch
2-n-1 ESC/Receiver Unit
8
9
7
6
5
4
3
2
BATTERIES
Radio:
This transmitter requires 4 AAA batteries.
1.
Remove the battery cover from the transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
CAUTION
: If using rechargeable batteries, charge only rechargeable
batteries. Charging non-rechargeable batteries may cause the batteries to
burst, resulting in injury to persons and/or damage to property.
CAUTION
: Risk of explosion if battery is replaced with an incorrect type.
Dispose of used batteries according to national regulations.
Battery Connector
NiMH Battery
Steering Servo
Steering Wheel
1.
Controls direction (left/right) of the model
Throttle Trigger
2.
Controls speed and direction (forward/brake/reverse) of the model
On/Off Switch
3.
Turns the power on/off
TH Trim
4.
Adjusts the throttle trim/dual rates
ST Trim
5.
Adjusts the steering trim/dual rates
CH 3
6.
Indicator Lights
7.
Solid blue light—Indicates radio connectivity and adequate battery power
Flashing blue light—Indicates the battery voltage is critically low. Replace batteries
REV
8.
Reverses the steering wheel and throttle functions
Antenna
9.
Transmits the signal to the model
1
Vehicle:
Charger
1.
Switch off the vehicle and remove the battery.
2.
Carefully connect the battery to the charger.
3.
Plug the charger into an AC wall outlet.
4.
The charging process takes approximately 2 hours. Unplug the battery when
charge is complete.
WARNING
included NiMH charger to charge the included NiMH battery. Never
charge a LiPo battery with a NiMH charger.
: Never leave charging batteries unattended. Only use the
Battery