Dromida Ocular 빠른 시작 비행 매뉴얼 - 페이지 4
{카테고리_이름} Dromida Ocular에 대한 빠른 시작 비행 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dromida Ocular 13 페이지.
페이지 인쇄HOW to FLY
D
B
C
D
A
B
A
Basic Flight
Press and hold the Motors Start/Stop button until the motors start
to spin. Tap the AUTO TAKEOFF/LAND button and the Ocular will take off and hover
about 3 feet (1 meter) above the floor. OPTION: After the motors are armed with the
MOTOR START/STOP button, the throttle stick can also be used to manually take off.
Slowly advance the throttle and release it when the Ocular reaches the desired height.
The controls are sensitive and the control sensitivity should be in the low setting
if flying indoors. Small movements of the pitch, roll and yaw control sticks
should be used to move the Ocular. Raise or lower the throttle stick to change
the Ocular's altitude. When the drone is at the desired height, release the throttle
stick so the Altitude Hold sensor can maintain the Ocular's height. If you get into
trouble and see that the drone is going to crash, press the MOTOR START/STOP
button to stop the motors as soon as possible.
Sensitivity Adjustment
to change the sensitivity of the controls.
Sensitivity
Beep
Flight Mode LED
Low
1
Blue
High
2
Purple
Flips
Push down on the left stick and release it when the controller beeps.
Move the right stick in the direction desired and release it when the Ocular
starts to flip.
IMPORTANT: Flips cannot be done when the LEDs indicate the battery voltage
is low.
B
A
C
A
D
B
C
C
D
Push down on the right stick
E
E
Low Voltage Alarm
voltage is getting low. Land the Ocular as soon as possible and charge the
battery. The battery must be charged before it is stored. ALWAYS disconnect
the battery when it's not in use!
Headless Mode
mode, the Ocular movements will be relative to
the controller no matter which way the drone
is pointing. When you push forward on the
controller for example, the drone moves away
from you even if the camera is pointing to the
side or at you. When the Headless Mode is
active, the LEDs will flash slowly. For Headless
Mode to work:
1. The tail of the drone MUST face the pilot when the drone is fi rst plugged in
and set down.
2. The pilot must not change position or direction after the controller and drone
are linked.
CORRECTING DRIFT
It is normal for the Ocular to drift slightly. However, if it drifts in any direction
consistently, press the trim button that is opposite the movement as many times
as needed to eliminate the drift.
SENSOR CALIBRATION
It is normal for the Ocular to require minor corrections while hovering. If the quad
has a strong tendency to drift in one direction, the sensors may need calibration.
1. Power up and link the controller
and the Ocular.
2. Place the quad on a level surface.
3. Center all the trims.
4. Hold both sticks in the lower right
corners. When the LEDs on the
arms start to fl ash rapidly, release
the sticks. Do NOT move the Ocular
until the LEDs are steady again.
APP
The Ocular will link to an app on your iOS/Android based mobile
device so the Ocular can be flown in the FPV mode.
To download the app, open the App Store on your device and
enter "Horizon Hobby" as a search term. Select the Dromida app.
E
LINKING to the APP
E
With the Ocular turned on, open the
Wi-Fi settings on your device and
E
select the "UFO-....." network.
4
The LEDs on the arms will flash when the battery
When you active this