Drone Sky Hook DSH-DRDP2-P4 빠른 작동 매뉴얼 - 페이지 2

{카테고리_이름} Drone Sky Hook DSH-DRDP2-P4에 대한 빠른 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drone Sky Hook DSH-DRDP2-P4 3 페이지. Arrow single/dual release & drop for phantom 4 / phantom 3 series drones, arrow single/dual release & drop plus for phantom 4 / phantom 3 series drones

페이지 인쇄

Controlling the Dual Drop Wheel

DSH Models: Dual Release & Drop / Dual Release & Drop PLUS

Operation Mode 1 – Drone Rotation

Remote Controller (Mode 2)

LEFT STICK

Operation Mode 2 – Drone Remote Controller C1/C2 Button and/or DJI App

Note: Use the DJI App to assign C1 or C2 button to Turn On/Off front LEDs

Remote Controller

C1 / C2 Button

DJI App

Settings – Main Controller Settings – Advanced Settings

Operation Mode 3 – Manual – FUNC button on DSH unit

DSH Release & Drop unit

IMPORTANT NOTE: At the end of each operation wait 3 seconds for the execution your command and before the initiation of the next command (False Command

Avoidance Algorithm (FCAA)).

DRONE SKY HOOK Ltd

For Installation and Operation videos visit

Quickly Rotate (YAW) the drone two full turns counter clockwise to drop the first payload.

Quickly Rotate (YAW) the drone again two full turns counter clockwise to drop the second payload.

To set the drop wheel back to its previous position, Quickly Rotate (YAW) the drone again two full turns counter clockwise.

Press C1 or C2 twice in quick succession (while maintaining about 0.5-1 second between each press) to drop the first

payload.

Press C1 or C2 twice again in quick succession (while maintaining about 0.5-1 second between each press) to drop

the second payload.

To set the drop wheel back to its previous position, again press C1 or C2 twice in quick succession (while maintaining

about 0.5-1 second between each press).

In the App menu switch the drone's front LEDs ON, then OFF and then back ON or OFF, then ON and then OFF.

(Total of one ON-OFF-ON or OFF-ON-OFF cycle) to simulate the operation of the C1 or C2 buttons on the drone's

remote controller (see above).

Maintain about 0.5-1 second idle duration between each switch operation.

Press twice the device's FUNC button to simulate the operation of the C1 or C2 buttons on the drone's remote

controller (see above).

Maintain about 0.5-1 second idle duration between each operation of the FUNC button.

www.droneskyhook.com/product-support

Operation