Elegoo MARS 4 Series 사용자 설명서 - 페이지 9

{카테고리_이름} Elegoo MARS 4 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Elegoo MARS 4 Series 20 페이지.
Elegoo MARS 4 Series에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

1. Software Installation and Setup

Leveling

Pull the leveling card. If you ﬁnd there is a slight resistance during this process, you can go

directly to step 5.

(Note: If there is no resistance when pulling out the leveling card, please click

the Z-axis "down" button (in steps of 0.1mm) until there is a slight resistance to pull the leveling

card. If there is too much resistance or the leveling card cannot move, please click the Z-axis "up"

button (in steps of 0.1mm) until there is slight resistance to pull the leveling card.)

4. After completing the above operations, back to the previous menu, and click "Set Z=0", then a

conﬁrmation pop-up window will appear in the interface, click "Conﬁrm" to complete the setting.

At this time, the current Z-axis position is reset to the new initial height of the ﬁrst printing layer.

(See Picture 5)

(See Picture 4)

(Picture 4)

(Picture 5)