Elegoo Saturn 4 Ultra 사용자 설명서 - 페이지 3

{카테고리_이름} Elegoo Saturn 4 Ultra에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Elegoo Saturn 4 Ultra 17 페이지.

Notice:

Please keep the 3D printer and its accessories out of the reach of children.

Please ﬁll the resin tank no less than 1/3 of its volume, but do not exceed the MAX line position.

Please place the printer in a dry environment and protect it from rain and moisture.

If you run into an emergency during use, please turn oﬀ the power supply of the 3D printer ﬁrst.

Please use the printer indoors and avoid direct sunlight and a dusty environment.

Please keep the original packaging box for 30 days for return/exchange (only ELEGOO original

packaging boxes are accepted).

If the printing fails, you need to clean the excess cured resin in the resin tank and change the

resin, otherwise, it may cause damage to your printer.

When operating the 3D printer, please wear a mask and gloves to avoid direct skin contact with

the photopolymer resin.

If the release ﬁlm in the resin tank is whitened, scratched, or has no elasticity, the printing failure

rate is high, please replace the release ﬁlm in time.

Please use 95% (or higher) ethyl alcohol or isopropyl alcohol to wash your model unless you are

using water washable resin.

If you have any problems with the printer, please contact us at [email protected]. Please do not

disassemble or modify ELEGOO 3D printers by yourself, otherwise, the warranty will expire, and

damage caused by personal operating errors need to pay for repairs.