DROPSA 0400605 사용자 및 유지보수 매뉴얼 - 페이지 9
{카테고리_이름} DROPSA 0400605에 대한 사용자 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DROPSA 0400605 10 페이지. Pneumatic pumps trolley mounted
페이지 인쇄
11.2 - 25 pneumatic pump trolley mounted
12. HANDLING AND TRANSPORT
Before shipping, the units are carefully packed inside cardboard boxes. When transporting and storing the equipment, pay
attention to the direction indicated on the boxes themselves.
Upon receipt, check that the package has not been damaged and store the equipment in a dry location.
Manual handling must be carried out by at least two people.
Lift the equipment bearing in mind the direction indicated on the box.
During storage, the machine components can withstand temperatures from
-20 to +65°C. However, in order to prevent damage, start-up must take place when the machine has reached a
temperature of +5 °C (23°F).
13. OPERATING HAZARDS
It is necessary to carefully read about the instructions and the risks involved in the use of sealant injection equipment.
The operator must understand its operation and clearly understand the hazards connected to pumping pressurised sealant.
Therefore we recommend the following:
•
Check the chemical compatibility of the material with which the pump is built with the sealant to be pumped (See chap. 4).
An incorrect selection could cause, in addition to damaging the pumps and pipes, serious risks for people (spillage of
irritating products that are harmful to health) and for the environment.
•
Never exceed the maximum operating pressure permitted for the pump and the components connected to it. In the case of
doubt, refer to the data specified on the pump label.
•
Only use original spare parts.
•
If components must be replaced with others, make sure they are suitable for operating at the pump's maximum operating
pressure.
WARNING!
Never try to stop or deviate any leaks with your hands or other body parts.
9