DROPSA 3413012 사용 설명서 지침 - 페이지 4

{카테고리_이름} DROPSA 3413012에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DROPSA 3413012 11 페이지. Pneumatically driven pump

2.2

Fixing dimensions

2.3

Other data

NLGI grease rating at working temperature

Viscosity of the lubricant at working temperature

Working temperature

Working humidity

Preservation temperature

Sound pressure level

3.0

CORRECT USE

3.1

Putting into service

♦ The unit may be used, opened and repaired only by specialised personnel.

♦ The pump MUST NOT be submersed in fluids or utilised in environments which are particularly aggressive or

explosive/inflammable if not prepared for this purpose beforehand by the supplier.

♦ For correct fixing verify the distance between centres shown in the diagram in Section 2.2.

♦ Use gloves and safety glasses as required in the lubrication oil safety chart.

♦ DO NOT use aggressive lubricants with NBR gaskets and seals; if in doubt consult the Engineering Department

of Dropsa SpA, who will provide a chart with the details of recommended oils.

♦ DO NOT ignore dangers to health and observe all hygiene standards.

♦ WARNING! All electrical components must be grounded. This refers to both electrical components and control

devices. In this regard ensure that the ground cable is correctly connected. For reasons of safety the ground cable

must be approx. 100 mm longer than the phase cables. In the event of accidental detachment of the cable, the

ground terminal must be the last to be removed.

C20008IE – Pneumatically driven pump - Rev. 0

see table at sub-section 4.0

Between 15 - 2000 cSt

+ 5 - + 80 ° C

90 % relative humidity.

- 20 - + 50 °C

< 70 dB(A)

February 99

Page 4 of 9