Daikin BRC7FB532F 운영 매뉴얼 - 페이지 6
{카테고리_이름} Daikin BRC7FB532F에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daikin BRC7FB532F 12 페이지. Wireless remote controller kit
페이지 인쇄
Operation range
■ Refer to the operation manual provided with the
indoor unit or with the outdoor unit.
■ If the indoor temperature or humidity is beyond
operating conditions as listed in the indoor unit or
outdoor unit manuals, it may happen
- that safety devices work,
- that the air conditioner does not operate,
- that water drips from the indoor unit.
■ The setting temperature range of the remote
controller is 16°C to 32°C.
Operation procedure
■ To protect the unit, turn on the main power switch 6
hours before operation.
■ If the main power supply is turned off during
operation, operation will restart automatically after
the power turns back on again.
Cooling,
Heating,
Program dry operation
Operate in the following order:
AUTOMATIC OPERATION can be selected only by
heat pump system or heat recovery VRV system.
For systems without a cool/heat changeover remote
control switch
1
OPERATION MODE SELECTOR
See figure 1
Press the OPERATION MODE SELECTOR button
several times and select the OPERATION MODE of
your choice as follows:
- COOLING operation ......................................
- HEATING operation .......................................
- AUTOMATIC operation.................................
- In this operation mode, COOL/HEAT
changeover is automatically conducted.
- FAN operation................................................
- DRY operation ...............................................
- The function of this program is to decrease
the humidity in your room with the minimum
temperature decrease.
- The set point is the air temperature when
starting operation by dry operation.
- Micro computer automatically determines
TEMPERATURE and FAN SPEED.
- This system does not go into operation if the
room temperature is below 16°C.
Operation manual
4
Automatic,
Fan
4P563995-1 2019.01
2
Press ON/OFF button.
OPERATION lamp lights up or goes off and the
system starts or stops OPERATION.
Do not turn OFF power immediately after the
unit stops. Then, wait no less than 5 minutes.
Water is leaking or there is something else
wrong with the unit.
For systems with cool/heat changeover remote control
switch
1
See figure 4
Select OPERATION MODE with the COOL/HEAT
CHANGEOVER REMOTE CONTROL SWITCH as
and
follows.
COOLING operation.........................
HEATING operation..........................
FAN operation ..................................
DRY operation ..................................
Press OPERATION MODE SELECTOR button
several times and select "
See "For systems without a cool/heat changeover
remote control switch" on page 4 for details on dry
operation.
(This
operation
operation.)
2
Press ON/OFF button.
OPERATION lamp lights up or goes off and the
system starts or stops OPERATION.
Do not turn OFF power immediately after the
unit stops. Then, wait no less than 5 minutes.
Water is leaking or there is something else
wrong with the unit.
ON/OFF
OPERATION MODE SELECTOR
".
is
only
available
ON/OFF
BRC7FA532F(B) + BRC7FB532F(B)
Wireless remote controller kit
during
dry