DROPSA Flow master 사용자 및 유지보수 매뉴얼 - 페이지 9
{카테고리_이름} DROPSA Flow master에 대한 사용자 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DROPSA Flow master 12 페이지. Volumetric flow meter for controlling the flow of liquids. manual or motorized adjustment
페이지 인쇄13. HANDLING AND TRANSPORTATION
Given the low weight and small dimensions of the machine, it is not necessary the use of material handling equipment.
Prior to shipping, the machine is carefully packed in cardboard packing.
During transportation and storage, pay attention to the side on the cardboard packing.
On receipt, check that the packing is not damaged and then, storage the machine in a dry location.
CAUTION: During storage, machine components can withstand temperatures –20 °C ÷ +60 °C (-4 °F ÷ +140 F°).
However, in order to avoid damages, machine starting should occur at a minimum temperature of +5 °C (+41
°F).
14. OPERATING HAZARDS
It is necessary to read carefully about the instructions and the risks involved in the use of lubrication components. The
operator must know machine functioning and dangers through the user manual.
Power supply
Any type of intervention must not be carried out before the unplugging of the machine from the power supply. Make sure that
no one can start it up again during the intervention.
All the installed electric and electronic equipment, reservoirs and basic components must be grounded.
Inflammability
The lubricant generally used in lubrication systems is not normally inflammable. However, it is advised to avoid contact with
extremely hot substances or naked flames.
Pressure
Prior to any intervention, check the absence of residual pressure in any branch of the lubricant circuit as it may cause oil sprays
when disassembling components or fittings.
Noise and vibrations
FLOW MASTER does not produce excessive noise, less than 70 dB(A).
15. PRECAUTIONS
No particular operating hazards characterize the FLOW MASTER, except for the following precautions:
The operator must be provided with suitable personal protective clothing and devices
Lubricants containing abrasive components
Lubricants containing silicon
Petrol – solvents – inflammable liquids
Corrosive products
Water
Food Products
Operator's contact with lubricant during maintenance tasks:
Use of incompatible lubricant:
Fluids
MAIN NO COMPATIBLE FLUIDS
Premature wear of pump
Pump failure
Fire – explosion –seal damage
Pump damage - danger to persons
Pump oxidization
Contamination of the product
.
Dangers
9