anko SBL-1208A 사용자 설명서 - 페이지 7

{카테고리_이름} anko SBL-1208A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. anko SBL-1208A 15 페이지. Frozen drink maker

OPERATION

Place the appliance on a flat stable, water-resistant surface near an electrical

outlet before starting. Make sure the cord is away from any water source. It is

acceptable to use an extension cord if needed. DO NOT plug in the appliance

into mains power at this time.

Place the ice shaving chamber into the motor housing so it is seated on the

shaft. Twist the

Make sure that the ice shaving chamber is free from any foreign objects.

Insert the mixing paddle into the slot in the center of the pitcher.

Fill the pitcher with your favorite beverage, liquor, juice or drink mix.

NOTE: Use the lines indicated on the side of the pitcher as a guide for how much

liquid to add. You may choose to make a small or large serving.

Slide pitcher into place on base and turn clockwise until it stops. This will allow

the mixing paddle to mix ice and ingredients once the operation begins.

Turn the selector knob to the desired setting. SLUSH produces a finely shaved

ice; SNOW produces a coarser textured ice.

Place ice in ice shaving chamber. Add enough ice cubes, but not above the top

of ice shaving chamber.

BE CAREFUL when placing ice cubes in ice shaving chamber. The blade is very

sharp.

Plug cord into a mains power outlet.

When you are ready to start making your frozen drink, place the lid on the

appliance and turn counter-clockwise to engage the interlock switch (to turn

power ON/OFF).

chamber lock

in the direction of the arrow to lock into position.