Daikin DPS 설치 및 유지 관리 매뉴얼 - 페이지 16

{카테고리_이름} Daikin DPS에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daikin DPS 20 페이지. Space sensor
Daikin DPS에 대해서도 마찬가지입니다: 설치 매뉴얼 (6 페이지)

11. Click 'Save changes' button

a. IMPORTANT: Allow the page to refresh

b. Confirm that there is number in parentheses next

to "Review Changes". If so, proceed to step 12; if

not, repeat steps 8-11.

12. Remove 'wwan' interface

13. Remove 'wlan0' interface

14. Click the 'Save Changes' button

a. IMPORTANT: Allow the page to refresh

b. Confirm that there is number in parentheses next

to "Review Changes". If so, proceed to step 15; if

not, repeat steps 8-14.

15. Click the 'Apply Changes' button in the lower right-hand

corner of the screen. The page will automatically refresh

when complete (this can take as much as two minutes).

Figure 17: M2M Gateway Home Page

IM 1229-1 • INTELLIGENT EQUIPMENT

16. Confirm that 'ICMP host' of "wan" interface is still set to

"disable"

a. If so, go to step 17.

b. If not, set to "disable"

c. Click 'Save changes' button

i. IMPORTANT: Allow the page to refresh

ii. Confirm that there is number in parentheses

next to "Review Changes". If so, proceed to

step 17; if not, repeat steps 8-16.

d. Click the 'Apply Changes' button in the lower

right-hand corner of the screen. The page will

automatically refresh when complete (this can take

as much as two minutes).

17. Click the 'System' tab, then click the Reboot button.

18. Reconnect the Ethernet cable between the M2M

Gateway and the MicroTech III controller. Procedure

complete.

NOTE: Be certain that the IT staff has allowed incoming and

outgoing internet traffic on TCP ports 80, 443, 3197,

3199, 5222, 5223 and 8080.

-u

ysTem