Elektra Beckum Compressor Mega 700 D 사용 설명서 - 페이지 6
{카테고리_이름} Elektra Beckum Compressor Mega 700 D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Elektra Beckum Compressor Mega 700 D 10 페이지. Elektra beckum compressor operating instructions
Elektra Beckum Compressor Mega 700 D에 대해서도 마찬가지입니다: (네덜란드어) 매뉴얼 (12 페이지)
페이지 인쇄
ENGLISH
3.
Set pressure regulator (27) to
required working pressure. The cur-
rent working pressure is indicated
by the regulated pressure gauge
(28).
A
Caution!
Before connecting an air tool,
make sure the max. operating pres-
sure of the air tool used is not excee-
ded!
4.
When using lubricated air adjust
amount of oil to be added with the
regulator knob (29).
29
5.
Connect air tool.
You are now ready to work with the
air tool.
6.
Switch the compressor OFF, if you
do not continue working immediately
afterwards. Unplug after switching
OFF.
5. Care and Maintenance
A
Danger!
Prior to all servicing:
− Switch Off.
− Unplug.
− Wait until the compressor has
come to a complete stop.
− Ensure the compressor and all air
tools and accessories connected
to it are relieved from pressure.
After all servicing:
− Check to see that all safety
devices are operational.
− Make sure that no tools or other
parts
remain
on
machine.
Repair and maintenance work other
than described in this section must
only be carried out by qualified speci-
alists.
14
5.1
Periodic maintenance
Prior to each use
•
Check oil level of lubricator (30), top
up with pneumatic oil if necessary.
•
Check
replace if necessary.
•
Check all screwed connections for
tightness, tighten if necessary.
•
Check power supply cable for dam-
age, if necessary have replaced by
a qualified electrician.
Every 50 operating hours
•
Check air filter element (31) of com-
pressor pump, clean if necessary.
•
Check oil level (32) of compressor
pump, top up if necessary (33).
32
or
in
the
34
30
air
hoses
for
damage,
31
33
•
Drain condensate from pressure
vessel (35).
•
Clean air filter element (36) of filter/
regulator unit.
•
Drain condensate from filter/regula-
tor unit (37).
•
Check V-belt:
− Remove belt guard (38).
− Retension V-belt or replace, if
necessary.
− To adjust the V-belt tension,
loosen the four screws at the
motor base and shift the motor.
− Tighten the screws at the motor
base again.
− Replace the belt guard.
38
35
36
37