anko LD-K3068 사용자 설명서 - 페이지 6

{카테고리_이름} anko LD-K3068에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. anko LD-K3068 10 페이지. Wi-fi cordless water kettle



To avoid scale deposits, descale the water kettle at regular intervals (after about every

15th use) as described in the section "Descaling".

Connecting with Wi-Fi router

1. If the kettle is powered on for the first time, WiFi key light will flash

to remind user to connect to the network. If the light flashes quickly,

the appliance is in config mode. If the light flashes slowly, hold the

WiFi key for more than 3 seconds and the kettle will 'beep' once, the

light will turn to flash quickly, and the appliance will revert to config

mode.

2. In the process of connecting the appliance to the Wi-Fi router, the light on the Wi-Fi button

will go out for a few seconds. When the process has ended, the buzzer will sound once and

the Wi-Fi button will light up for 5 seconds. The appliance is now successfully connected to

the Wi-Fi router.

3. After the kettle has successfully connected to the network once, it is not necessary to

reconfigure the connection when powered ON again. The kettle will be automatically connect

to the network.

4. If the appliance has connected with the Wi-Fi router, you can control the kettle and see the

status through your mobile phone from anywhere with a network connection.

5. Hold the Wi-Fi key for more than 3 seconds again will reset the appliance.

6. The appliance can be used normally without connecting to the network. The flashing Wi-Fi

light will switch off after a couple of minutes from switching the kettle ON.

Heating water

WARNING: Risk of scalding from hot water

 The kettle and its lid become hot while in use. Do not touch.

 The lid must be tightly closed during the boiling process. It must not be opened while

pouring out water. Allow the appliance cool down before opening the lid.

 Do not fill the water container with less than MIN. (0.5L) or more than MAX. (1.7L) of water.

1. Hold the lid handle and pull it up to open the lid.

2. Fill the kettle with the amount of water required. You

can check the fill level on the water level indicator on

the kettle.

3. Press the lid down firmly to close it.

Make sure that the lid is closed properly;



otherwise the water may not reach the

WiFi

key

Lid

handle