anko MC609 매뉴얼 - 페이지 11

{카테고리_이름} anko MC609에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. anko MC609 16 페이지. Wet & dry vacuum cleaner for indoor and patio use

Safety Devices Operation

NOTE: The motor has an overheating protection device built in.

It will automatically switch off power to the motor if it overheats. e.g., from

blocked nozzles, a full Dust Canister or uncleaned and blocked filters.

If this happens, turn off the vacuum cleaner and unplug from the power socket,

clean blockage and / or filters and allow to rest for at least 60 minutes which

should be enough time for the motor to cool down.

Important: If the over-temperature device activates and turns the motor off,

and you do not switch off and unplug the appliance from the power point, the

motor will restart automatically after it has cooled down enough to reset the

safety device.

NOTE:

NEVER BLOCK any VENTS or OPENINGS and KEEP FILTERS CLEAN.

Empty the Dust Canister as frequently as possible or when the suction power

is reduced.

Turn off the power and unplug from the power point first.

Remove the Flexible Hose.

•

To remove the Dust Canister from the top Motor Housing, unlatch the

•

two side latches as described previously in the section "Side Latches"

then lift the Motor Housing up and away from the lower dust canister.

Take the dust canister to a dustbin and tip out the contents.

•

Brush the inside of the dust canister with a small brush or wash. Refer

•

to section "Cleaning".

•

To refit the Motor Housing and Dust Canister, place the motor housing

back on the dust canister and align the side clamps.

Lift and place the clamp back on the clamp blocks, and then push the

•

clamp lever inward to the vacuum cleaner body until it snaps closed.

NOTE: It is important that the Clamp Blocks on the side of the motor

housing are properly aligned with the Clamps so as to prevent

excessive stress on the clamps.

Page 11 of 16