anko V8273-L-9 사용자 설명서 - 페이지 8

{카테고리_이름} anko V8273-L-9에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. anko V8273-L-9 10 페이지.

STORAGE

Wall Mount

There is a wall mount accessory

supplied with screws and wall

plugs.

To install the wall mount bracket,

position it on the wall at a suitable

height.

Mark the two screw holes through

onto the wall. Using a suitable drill

(wood drill bit for timber wall, or

masonry drill bit for brick /

concrete walls, drill three holes

Ø6mm and 35 - 40mm deep.

Insert the plastic wall plugs into

each hole and gently hammer in

until they are flush with the wall,

place the hanging mount over the

holes then insert the screws and

tighten up. Do Not Overtighten

Insert the DC jack through the

bottom hole of wall mount bracket,

twist in 90deg to hold it at base

Seat the handheld vacuum on the

wall mount bracket, the vacuum

can start charging in this position.

IMPORTANT! If unsure of the

above installation process consult

a professional person to have it

installed.