Beckmann+Egle MD3150 사용 설명서 - 페이지 10

{카테고리_이름} Beckmann+Egle MD3150에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Beckmann+Egle MD3150 16 페이지.

MD3150/3060

Calibration mode: Only for service

Mode E:

Mode display

The letter 'E' is shown in the mode display.

The small + large displays show the count value of the internal A/D converter. This

mode is only used for service work.

IMPORTANT:

If you enter calibration mode accidentally, hold the minus key pressed until the

software returns to the normal operating mode (Mode 0).

Maintenance, disposal

Please observe the following instructions :

•

Spent batteries are hazardous waste and must be disposed as prescribed by law.

•

Do not use carbon-containing chemicals or fuel, alcohol or similar fluids for cleaning.

• • • •

Damage due to non-compliance with the above instructions is not covered by

guarantee.

Problem

The device does not display

temperature but only meaningless

characters

Not all modes can be entered

When the device is switched on it does

not go to temperature display mode

(MD3060)

10,000 digit of A/D value

Page 10

Small display

Possible remedy

You are probably in calibration mode. Press the

minus key to return to normal operating mode.

An interval measurement has not been completed

and is still active; see description of mode 3

No sensor connected or sensor defective

Large display

1,000 digit of A/D value

Internet: www.bue.de