BECKWITH ELECTRIC BlueJay M-2910 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} BECKWITH ELECTRIC BlueJay M-2910에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BECKWITH ELECTRIC BlueJay M-2910 8 페이지. Wireless data transceiver

M-2910 BlueJay Universal Data Transceiver

Power

The M-2910 is powered by 5 V dc, supplied by the SPI interface connector. Maximum power draw is 1.75 W

(350 mA).

Power Requirements:

• Operating Voltage – +5 V dc

• Transmit Current – 350 mA (1.75 W)

• Receive Current – 350 mA (1.75 W)

• Idle Current – 200 mA (1.00 W)

• Sleep Current – 30 mA (0.15 W)

Configuration

The M-2910 is configurable using parameters set into the M-2600A/M-2667A, using SlimCom

parameters can be set:

• Wireless Source (unit) Address (1–250)

• Wireless Destination (Transmit) Address (1–255)

• Wireless Multicast (Receive) Address (251–254)

• Peer-to-Peer Unit Addresses (1–250)

Configuring the M-2910

To configure the M-2910, the unit must be installed on an M-2600A/M-2667A control, and the control

connected to a PC running SlimCom, using a RS-232 cable. The unit may be configured through the

SlimCom menus

10%

–4–

: The following