ANLIDAR MyTorq MY8-EP0103P 운영 및 유지보수 매뉴얼 - 페이지 11

{카테고리_이름} ANLIDAR MyTorq MY8-EP0103P에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANLIDAR MyTorq MY8-EP0103P 13 페이지. Dc-type automatic non-carbon-brush with counter series

페이지 인쇄

※Push R key to restore to factory settings.

General execution of pre-set program:

N.G

Ht=2.0

Lt=0.02

N.G

＊ If stop is among dots, it is normal fastening. "OK"will be shown.

＊ If stop is before Lt or over Ht, it is "N.G.".

＊ User can freely adjust Lt. However, if Ht and Lt is closer, it will

LL=1.0

request more accuracy.