ANLIDAR MYTORQ MYBT-EP0612 운영 및 유지보수 매뉴얼 - 페이지 12
{카테고리_이름} ANLIDAR MYTORQ MYBT-EP0612에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANLIDAR MYTORQ MYBT-EP0612 19 페이지. Automatic industrial cordless brushless power torque screwdrivers series
페이지 인쇄2. Buttons on panel:
Button
Power wake up
UP
DOWN
Set / Select
Reset
UP
+
+
DOWN
Power wake up
+
+
Set / Select
Description
Press P to wake up sleep mode screwdriver.
In setting mode, press up to select and change value.
1. In setting mode, press down to select and change value.
2. Press and hold for 5 seconds to turn of counter function and turn off
display. Press and hold again for 2 seconds to resume counter function.
3. Press and hold for 3 seconds to clear counting.
1. Press and hold for 3 seconds to enter setting mode.
2. Press Set/Select in setting mode to go to next setting.
3. When NS triggered, press Set/Select to unlock.
Reset
Press R to reset (factory default setting).
Up+Down (switch to connect to wireless controller)
1.
Press up and down simultaneously for 10 seconds to connect
screwdriver to MY-WSIO. At this moment screwdriver settings must
be set from MY-WSIO.
2.
Press up and down simultaneously for 10 seconds to disconnect
screwdriver and MY-WSIO.
*Screwdriver default set as disconnected to MY-WSIO.
Power wake up + Set / Select
Press simultaneously for 5 second to enter learning mode.
11