ANLIDAR MYTORQ MYBT-SC0612 운영 및 유지보수 매뉴얼 - 페이지 4
{카테고리_이름} ANLIDAR MYTORQ MYBT-SC0612에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANLIDAR MYTORQ MYBT-SC0612 12 페이지. Semi-automatic cordless brushless power torque screwdrivers series
페이지 인쇄▉Over electric current protection
▉Thermal Protector
▉Slow rotation protection
▉Battery Identification
Do not attempt to repair or disassemble this cordless screwdriver, the warranty
will be considered void.
1.
This rechargeable screwdriver maintenance Make sure to remove the battery pack before
maintaining or repairing the device by a qualified technician.
2.
Do not attempt to disassemble or reassemble the device at will which may result in poor
performance or danger of injury, the warranty applies only to initial package.
3.
Do not repair the device with other than genuine MYTORQ replacement parts may result in poor
performance or danger of injury, the warranty will be considered void.
4.
The temperature between 0∘C ~35∘C would be an ideal condition of carrying out the tasks on the
device.
1.
Charge the battery in the charging station before first use to make sure operates at its highest
capacity. To ensure operators against injuries, release the forward/reverse lever as arrow showing
below into a center position to have trigger locked before start or disassemble the device.
2.1 Below illustration is showing the process of correct install & disassemble the rechargeable battery.
The beep sound comes along with a flash while the screwdriver is supplied genuine battery
installation. It could be operated once the battery has been identified.
Function of Cordless Protection
Operating Instructions
Forward / Reverse
lever
▉Prevent from low power
▉Stall protection
▉Reverse control protection
▉Sleeping mode
Warning
3