ABSINA 34-116-1002 운영 매뉴얼 - 페이지 12

{카테고리_이름} ABSINA 34-116-1002에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABSINA 34-116-1002 20 페이지.

5. INSTALLATION

1. After opening the wallbox, check it for completeness

and damage. In the event of damage, inform the

transport service immediately and do not install the

wallbox.

2. The wallbox may only be installed by trained

specialist personnel.

3. The connection on the input side must be made with

a suitable power cable with at least 5x2.5mm².

4. On the building side, each phase must be equipped

with an automatic circuit breaker and FI circuit

breakers and have the appropriate cable cross-

sections for the power.

5. Remove the cover of the connection strip on the

back of the unit using 4 screws (1). Feed the input

cable through the rubber grommet and secure it

with the strain relief using the retaining clip and 2

screws (2).

6. Remove the protective cover over the contact strip.

Screw the 3 phases, N & PE to the contact strip

using ring cable lugs according to the connection

diagram, insert the protective cover over the

contact strip and screw the cover back onto the

housing (1).

Deutsch . English