3M 718A 사용자 설명서 - 페이지 11

{카테고리_이름} 3M 718A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 718A 14 페이지. Static sensor
3M 718A에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

5.5.6 The instrument should now be reading

1.000. If it is not, remove the battery

door and use a screwdriver to turn the

small screw located inside the battery

compartment. Use a small screwdriver to

turn the small screw, located on the front

right side of the instrument. This screw

should adjust the reading on the display.

Once the display has been adjusted to read

1.000, the low range of the 3M

Sensor 718 is now calibrated.

5.5.7 Repeat procedures 5.5.2 - 5.5.6 for the high of the meter, using a test

voltage of 5,000 volts.

6.0 Physical Characteristics (All values typical)

(at 1 inch (2.54 cm) distance from sensor to target)

Static Sensor 718

™

Description

Dimensions

Weight

Operating Conditions

Enclosure

Power Requirements

Measurement Ranges

Voltage Display

Display Resolution

Static

™

Typical Value

0.85" H x 2.4" W x 4.2" L

2.2 cm H x 6.1 cm W x 10.6 cm L

4.4 oz. (125 g) with battery

41º F - 95º F (5º C - 35º C)

Up to 80% RH, non-condensing

Indoor use only

For use at altitudes below 42, 300 ft. (2,000 m)

Pollution Degree II

Class III

Conductive Housing

One 9-volt alkaline battery

0 – 1,990 kV

0 – 19,900 kV

Liquid Crystal Display

1V/inch (0.39V/cm) @ low range

10V/inch (3.9V/cm) @ high range

± 10 counts