Druck InstruMetrics ADTS542F 안전 및 설치 매뉴얼 - 페이지 11

{카테고리_이름} Druck InstruMetrics ADTS542F에 대한 안전 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Druck InstruMetrics ADTS542F 16 페이지. Air data test set

WARNING

disconnecting device.

To disconnect power to the test set, either:

Remove the power cable (5) from the front of the test set, or

Remove the power cable from the wall socket. The wall socket connection must remain

accessible.

3.2 External Functional Earth/Ground Terminal

An external earth/ground connection stud (6) is available as a functional earth on the front panel

providing a connection/bonding point for other equipment to be connected to the same

earth/ground connection as the test set (This is not a protective earth/ground connection).

3.3 Pneumatic Connections

No external pneumatic pressures or vacuums are required as the ADTS contains internal

pressure and vacuum pumps.

Hoses (available as orderable accessories on the datasheet) are used for connection to the

"Pitot" (Pt) (1) and "Static" (Ps) (2) output ports of the ADTS.

The "Pitot" (Pt) and "Static" (Ps) outputs can then be connected to the corresponding Pitot and

Static connectors on the aircraft or aeronautical instruments.

The maximum Pt and Ps output pressure is 2 bar absolute.

The following table details the possible connector specifications:

Mating female parts are available from Druck.

3.4 Cleaning

CAUTION

The following materials are approved cleaning agents:

Note: Equivalent alternatives may be used for listed items.

The On/Standby Switch (3) on the front of the test set is not a

Name

G1/8

Pipe Thread ISO 228 - G 1/8 B

AN3

AN4

AN6

Do not use solvents to clean this equipment.

Material

Lint-free cloth

Damp cloth

Mild detergent

Soft brush

Specification

3/8 - 24 UNJF - 3A Thread

7/16 - 20 UNJF - 3A Thread

9/16 - 18 UNJF - 3A Thread

Specification

Commercially available

English–ADTS Safety and Installation Guide | 9