Becos TS8-MS Overdrive Midi Switching 빠른 설정 - 페이지 3
{카테고리_이름} Becos TS8-MS Overdrive Midi Switching에 대한 빠른 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Becos TS8-MS Overdrive Midi Switching 4 페이지. Analog overdrive with external relay switching and midi functions
Becos TS8-MS Overdrive Midi Switching에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (6 페이지)
페이지 인쇄Set TS8-MS pedal to transmit or receive MIDI
Inside the pedal there are two small 4-pin sockets: one socket is for MIDI Receive function (factory default) and another
for MIDI Transmit function. The external 5-pin MIDI connector is connected to the circuit board on one socket or the
other, through a 4-wire jumper cable. Only one function can be used at a time.
MIDI Control - Program Change
TS8-MS pedal is pre-programmed to respond to the following Program Change numbers:
Program Change
Number
#50
#51
#52
#53
#54
#55
#56
#57
MIDI Control - Control Change
TS8-MS pedal is pre-programmed to respond to the following MIDI Control Change numbers:
Control
Change
Number
Note: Bypass = Effect/Bypass Relay. R1 = External Switching Relay 1 (Tip-to-Ground). R2 = External Switching Relay 2
(Ring-to-Ground).
Bypass / Effect
Relay
Bypass
Bypass
Bypass
Bypass
Effect
Effect
Effect
Effect
Table 2 - MIDI Program Change switching options in TS8-MS
Relays Controlled
80
Bypass
81
R1
82
R2
83
Bypass, R1, R2
84
Bypass, R1
85
R1, R2
86
Bypass, R2
Table 3 - MIDI Control Change switching options in TS8-MS
http://midi-overdrive-switcher.becosfx.com/
Switching
Switching
Relay 1
Relay 2
Tip-To-Gnd
Ring-To-Gnd
Off
Off
On
On
Off
On
On
Off
Off
Off
On
On
Off
On
On
Off
Relay/LED
Relay/LED
OFF
ON
CC Value
CC Value
0-63
64-127
3