247Security mDVR514M 빠른 매뉴얼 - 페이지 7
{카테고리_이름} 247Security mDVR514M에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 247Security mDVR514M 13 페이지.
4. EQUIPMENT TEST
When all of the cameras, cables, and add-on modules have been installed and when the DVR is connected to your
on-site laptop, the completed setup needs to be tested. To begin the test, ensure the DVR's Hard Drive lock is turned
to the locked position and then turn the vehicle's ignition to ACC or ON. Starting the vehicle's engine—and, by
extension, the alternator to charge the battery—during the test is not essential. Ensure that you have direct line-of-
sight to the front of the DVR to see the LED indicators.
Note: At the first sign of a hazard/malfunction (electrical fire, smoke) immediately turn the vehicle's ignition OFF.
The 500Series DVR boot sequence is as follows:
Time Elapsed
Sequence
[minutes : seconds]
1
0:05
2
0:15
3
0:20
4
0:45
5
0:50
6
1:00
247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com
The IGN (ignition) indicator will turn on. The DVR is idling in Stand-By
mode. It is not online or recording.
The PWR (power) indicator will turn on while the IGN (ignition) indicator
will flash, repeatedly. The power LED on the Hard Drive will turn on. The
DVR is now undergoing its boot sequence.
The green POWER indicator on the Event Marker will turn on. The DVR
cooling fan (four channel DVR's) will turn on.
The IGN (ignition) and PWR (power) indicators will turn on solidly. The DVR
has completed its boot sequence.
The Hard Drive activity light will flash, signifying that the drive is now
recording data.
The amber RECORD light on the Event Marker will turn on solid, also
indicating that the hard drive is recording data. The DVR is now ready to
record, or to be serviced through the Ethernet Cable from your laptop.
NOTE: A NEW FEATURE OF THE '09, 500 SERIES DVR'S IS THAT WHEN
THE X-CROSS CABLE IS CONNECTED TO THE DVR FOR CONFIGURING THE
BUS AND AIMING CAMERAS, THE UNIT WILL NOT RECORD, AS SOON AS
YOU DISCONNECT THE X-CROSS CABLE FROM THE DVR WITH-IN 10
SECONDS THE DVR WILL AGAIN BEGIN RECORDING.
6
Activity