247Security mDVR602L 빠른 매뉴얼 - 페이지 4

{카테고리_이름} 247Security mDVR602L에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 247Security mDVR602L 14 페이지.

247Security mDVR602L 빠른 매뉴얼
CAMERA CABLES
Camera Cables (available in lengths of 15, 35 or 50 feet) use the STP (shielded twisted pair) cable standard. The
Camera Cables are connected using molded 2x3 Molex interfaces that are keyed to prevent improper mating. Each
connector uses a clip to snap securely to each camera and to the inputs on your DVR. The camera cables snap in
place with the cable clip facing towards the base of the DVR. After the installation, all Camera Cables should be
concealed and holes filled with grommets to protect the equipment from vandalism.
EVENT MARKER
The Event Marker is used for the driver to indicate a critical event during recording, which the DVR will interpret as a
priority video for later review. When the driver presses the event marker button, the DVR will mark all video feeds
from 150 seconds prior to and after the button press, 150 seconds is the factory default, but is programmable from
1 – 600 seconds. These priority event videos can be retrieved by the technician, using our USB memory stick, to be
viewed on a computer with the DVRViewer application installed.
The 600Series is unique in that an Event Marker is also built in to the front of the DVR and can be used in
conjunction with or in place of the external Event Marker cable.
The Event Marker module has one button, to signal an event, and 3 color lights to indicate three DVR states: green
for POWER; amber for hard drive RECORDING; and red for VIDEO LOST when a camera signal has been lost.
POWER CABLE
A three-wire, 12-feet-long Power Cable is used for connecting the DVR directly to the battery power in the vehicle's
electrical box. The cable uses a large molded 2x2 Molex connector that is keyed, thereby connecting to the DVR in
only one orientation. The cable's three wires are described in the following table:
POWER CABLE
DC IN (Red)
GND (Black)
IGN. ON/OFF (White)
Two screws (#4 thread, 3/8" long) are included to securely fasten the Power Cable to the DVR. Securing the Power
Cable to the DVR prevents occupants from deactivating the system by disconnecting the Power Cable.
IMPORTANT:
Make sure that both the RED (constant power) and white (ignition power) are fused in the electrical
box with 7.5 Amp fuses (not supplied).
247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com
BUS ELECTRICAL PANEL
Constant LIVE Power Source (battery side of solenoid, direct current)
Ground in bus electrical panel
Ignition-switched Power (live only if ignition is turned to ON/ ACC)
3