DrunkLizard X7 사용자 설명서 - 페이지 5

{카테고리_이름} DrunkLizard X7에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DrunkLizard X7 10 페이지.

페이지 인쇄

Brake hand bar

Function button

Power switch

LCD Display

Throttle lever

Instructions for Menu Buttons

Power switch:

press the power button for 2-3 seconds to turn the power on/off.

Acceleration:

press the right acceleration/throttle lever to start and accelerate.

Brake:

squeeze the brake handbar to brake. Lightly step on the rear fender brake to assist with extra braking power.

Press the function key to directly adjust the speed.

• Eco mode / Energy-saving mode / Beginner mode: no characters in the gear position

• Drive mode / Normal mode: gear characters display white "D"

• Sports mode: gear characters display red "D"

Headlights:

double tap the function button to turn on/off the headlights and taillights.

Brake lights light up (whether the headlights/taillights are on or off) when the disc brake/handbrake is engaged.

Cruise control mode:

keep the current speed for 6 seconds to enter cruise control, release when controller beeps.

To exit the cruise control mode, press accelerator again or squeeze the handbrake (squeezing the handbrake initiates the

brake light whether the headlights are on or off).

-07-

Speed

Error display

Multifunction

Gear

The unit display

Power

LCD display

2.2 Assembly instructions

1.Pull up the stem/folding

lever while pressing down on

the rear wheel fender.*

* Make sure the folding lever is against the stem when

closing and opening; to secure it, use the folding ring. (If

it isn't against the stem, the latch can catch and stop the

ability to close/open until it is tapped back up against the

stem.)

3. Affix the brake lever with the

2. Raise the stem; fasten the

folding latch and use the folding

included M6 hex wrench tightly.

(A lower position is reco mm ended

fixing ring to lock it in place.

so rider can naturally s q uee z e the

handbar.)

4. Adjust the folder screw only

5. Screw on the handlebars in the

direction of rotation to tighten.

if the stem is loose or too tight.

(Please note that the handlebars

screw on opposite of usual

direction so that rider doesn ' t

accidentally unscrew while riding.)

-08-