DRY AGER DX 500 사용 설명서 - 페이지 10

{카테고리_이름} DRY AGER DX 500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DRY AGER DX 500 17 페이지.
DRY AGER DX 500에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 교체 지침 (2 페이지)

페이지 인쇄

Air exchange with activated charcoal filter

Before reaching the lifetime a maintenance message appears in

the message display, see page 9.

Changing the filter:

Take the filter by the handle.

Turn it 90° to the left or right

and remove.

Inserting the filter:

Insert with the handle in a vertical

position. Turn it 90° to the left or

right until it clicks into place.

Cleaning

Before cleaning always switch off the appliance. Pull out the

mains plug or remove/unscrew the fuse.

• Clean the inside and outer walls with lukewarm water and a

little detergent. Do not use abrasive or acid cleaners or

chemical solvents.

• Use a glass cleaner to clean the glass surfaces and a

commercially available stainless-steel cleaning agent for the

stainless-steel surfaces.

Do not use steam cleaners because of the

risk of injury and damage.

• Ensure that no cleaning water penetrates into the electrical

components or ventilation grill.

• Do not damage or remove the type plate on the inside of the

appliance. It is very important for servicing purposes.

Malfunctions

You may be able to rectify the following faults by checking the

possible causes yourself.

• Appliance does not function:

– Is the appliance switched on?

– Is the plug correctly fitted in the mains socket?

– Is the fuse intact?

• Loud running noise:

– Is the appliance set up firmly on the floor?

– Does the appliance cause nearby items of furniture or objects

to vibrate? Please note that noises caused by the refrigerant

circuit cannot be avoided.

• The temperature is not low enough:

– Is the temperature setting correct (see "Setting the

temperature")?

– Does the separately installed thermometer show the correct

reading?

– Is the ventilation system working properly?

– Is the appliance set up too close to a heat source?

– If the backwall is iced, please defrost the Dry Ager overnight.

• The condensation freezes or does not expire in the

defrost water channel?

– Clean the drain opening on the right side with a suitable object

If none of the above causes apply and you cannot rectify

the fault yourself, contact the nearest customer service depart-

ment stating the type designation

service number

and appliance

number

as indicated on the

type plate.

The position of the type plate

is shown in the section entitled

Description of the appliance.