DRY AGER DX 1000 사용 설명서 - 페이지 9
{카테고리_이름} DRY AGER DX 1000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DRY AGER DX 1000 17 페이지.
DRY AGER DX 1000에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지)
페이지 인쇄
- 1. Disposal Notes
- 2. Saving Energy
- 3. Description of the Appliance
- 4. Integrated Systems
- 5. Safety Instructions and Warnings
- 6. Electrical Connection
- 7. Interior Light
- 8. Safety Lock
- 9. Display and Symbols
- 10. Key Combination
- 11. Error Messages
- 12. Alarm Acknowledgement
- 13. Changing over Door Hinges
- 14. Shutting Your Appliance down
Control ON and OFF
Press the button once for 5 seconds and the OFF
symbol
is displayed. The LED 4 (= standby)
The compressor is turned off . All relays are deactivated.
Press the button again and the compressor will restart.
Locking and unlocking the keypad
1. Press
and
of 3 seconds, POF appears for a few seconds
(POF = OFF parameter)
2. Thereafter, only displayed setting can not be
changed. Furthermore, the MIN and MAX values
can be viewed.
further activated.
Unlock
Press
and
hold the two keys for a minimum of 3 seconds.
Setting the Temperature and humidity
set
1. Press SET key: The set value is displayed and the
temp.
LED's fl ash
2. Now to change the settings, within 10 seconds,
use the
and
3. To confi rm press SET button or wait 10 seconds
Start manual defrost
Hold down button for a min. 2 seconds
The manual defrosting starts
and hold together, for a minimum
The ON / OFF switch can be
arrow keys
Error messages
Reasons for
Message
error messages
"P1"
Room sensor error
Evaporation
"P2"
temperature
sensor Failure
"P3"
Humidity Sensor error
"HA"
High temperature alarm
"LA"
Low temperature alarm
"HHA"
Moisture-HIGH alarm
"HLA"
Moisture-LOW alarm
"dA"
Door alarm
Displays the alarm message until the alarm conditions exist.
All alarms are displayed alternately with the room temperature
except for the P1. EE can be acknowledged by pressing any
key "rSt" for 3 seconds in the display, then returns to normal
operation.
Acknowledgement of the acoustic alarm
The audible alarm can be (optional) switched off by pressing
any key.
Alarm acknowledgement
Message P1, P2 and P3 after about 30 seconds; after correction
or troubleshooting, the error message disappears automatically.
Check probe sensor before replacing. Check connections.
Temperature alarms HA and LA will automatically reset once
the normal temperature is reached or when the defrost starts.
DA goes off when the door is closed. External alarms EAL and
BAL are disabled after the digital input. PAL acoustic alarm:
Through Device Turning off or standby ON / OFF.
Humidity alarms HHA and LHA are acknowledged automatically
when normal range has been reached.
Outputs
Cooling and Heating OFF
Defrost by time
moisture control OFF
regulation unaff ected
regulation unaff ected
regulation unaff ected
regulation unaff ected
regulation unaff ected
9