Anntlent AN-CPAL45 Plus 사용자 설명서 - 페이지 5
{카테고리_이름} Anntlent AN-CPAL45 Plus에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anntlent AN-CPAL45 Plus 9 페이지. Cell phone signal booster
페이지 인쇄
modified without the approval of the ANNTLENT company, otherwise it shall be
deemed invalid.
INSTALLATION INSTRUCTIONS
（1）Installation of Outdoor Antenna
The outside antenna comes with a strong magnet, simply put it on the roof of your
vehicle. Run the cable of the outside antenna from the nearest door to the booster
and connect the connectors by hand, please do not use any tools, otherwise it will
be over installed to break the connectors.
Note: Place the antenna at least 6 inches away from any windows including
sunroofs, and 12 inches away from any antennas on the vehicle.
（2）Installation of Indoor Antenna
The inside patch antenna should be stuck on the back of the front seat and face
the space you need to use your phone.
Note: Please don't mount it on any metal surface. The vertical installation is better
than the horizontal way. The inside antenna and outside antenna should be at least
6ft (2m) apart, if possible.
（3） Connect the Power Cord:
Connect the DC power cord into the vehicle's DC power source, verify that all of
the connections to the booster are tight and secure, plugging the power cord to the
booster, the green LED light will glow, indicating that the booster is ready to use.
WARNING: The booster is rated for DC 5~12V input voltage. DO NOT use the
booster with a high-voltage power supply. This could damage the booster or cause
personal injury.
（4） Mounting the booster (optional):
Select a location to install the booster that is away from excessive heat, direct
sunlight or moisture and that has proper ventilation. Recommended installation
locations are:
5 / 9