Anolis ArcPower 36 사용자 설명서 - 페이지 5

{카테고리_이름} Anolis ArcPower 36에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcPower 36 19 페이지.

Carefully prepare the end of the the supply cord and fit a suitable plug.A 3-prong grounding-type plug must be

installed following the manufacturer´s instructions.The earth has to be connected!

Cord plug connections:

Cable

Brown

Light blue

Yellow/Green

ETL version:

This version of ArcPower 36 is equipped with auto-switching power supply that automatically adjusts to any

50/60Hz AC power source from 100-120 Volts.

Connect the ArcPower 36 directly to AC power with the supply cord.

This device falls under protection class I.Therefore the ArcPower 36 has to be con-

nected to a mains socket outlet with a protective earthing connection.

4.2.Mounting the ArcPower 36

The ArcPower 36 should be be placed on a non-f lammable f lat surface in any orientation and fixed by the two

screws.There are two mounting holes of diameter 5 mm in housing of the driver. Ensure that instalation place

is enough ventilated.

1.The adapter cable RJ45/XLR connects the ArcPower 36 to the DMX controller.If your DMX controller has

RJ45 socket for DMX output,use RJ45 patch cable for connection with the ArcPower 36.

RJ45 plug

View facing pins

Pin 1: Not used

Pin 2: Not used

Pin 3: Not used

Pin 4: Not used

Pin 5: +5V

Pin 6: Data +

Pin 7: Data -

Pin 8: GND

International

Live

Neutral

Earth

Screw

Flat surface

DMX 512 XLR plug (male)

Front view of the plug

Screw

Mounting hole

Pin 1: GND

Pin 2: Data -

Pin 3: Data +

Pin 4: Not used

Pin 5: Not used