Anolis ArcWash Recessed 136 RGB 사용자 설명서 - 페이지 18

{카테고리_이름} Anolis ArcWash Recessed 136 RGB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcWash Recessed 136 RGB 19 페이지. Rgb

Data input/output

- 3-pin XLR male socket for DMX data input

- 3-pin XLR female socket for DMX data output

Temperatures

- Maximum ambient temperature: 40° C

- Maximum housing temperature: 55° C

Minimum distances

- Min. distance from flammable surfaces: 0.5 m

- Min. distance to lighted object: 0.5 m

Dimensions

Weight (net)

8.8 kg

Accessories

- Mounting bracket Omega CL assembled (2 pieces) .....................No. 99010420

- Frost film filter (soft).......................................................................No. 14060091

- Frost film filter (dense)...................................................................No. 14060092

Optional accessories:

- Flash cable RS232/DMX ...............................................................No.13050624

It is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fluid residues must not build up on or

within the fixture. Otherwise, the fixture's light-output will be significantly reduced. Regular cleaning will not only ensure

the maximum light-output, but will also allow the fixture to function reliably throughout its life.

A soft lint-free cloth moistened with any good glass cleaning fluid is recommended, under no circumstances should alcohol

or solvents be used!

DANGER !

Disconnect from the mains before starting any maintenance work

The front objective glass will require weekly cleaning as smoke-fluid tends to building up residues, reducing the light-output

very quickly. The cooling-fans should be cleaned monthly.

The interior of the fixture should be cleaned at least annually using a vacuum-cleaner or an air-jet.

More complicated maintenance and service operations are only to be carried out by authorized dealers.

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of same type and rating.

Before replacing the fuse, unplug mains lead.

Procedure:

1) Unscrew the fuseholder on the rear panel of the base with a fitting screwdriver from the housing (anti clockwise).

2) Remove the old fuse from the fuseholder.

3) Install the new fuse in the fuseholder.

4) Replace the fuseholder in the housing and fix it.

Specifications are subject to change without notice.

11. Maintenance and cleaning