Anolis arcpower smartwhite 72 사용자 설명서 - 페이지 13

{카테고리_이름} Anolis arcpower smartwhite 72에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis arcpower smartwhite 72 20 페이지.

8.Control board

The control panel situated on the top cover of the ArcPower SmartWhite 72 allows DMX addressing,calling

Built-in programs and setting the fixture behaviour

Control elements:

[ENTER] button- enters menu,confirms adjusted values and leaves menu.

[UP] button and[DOWN] button- moves between menu items on the the same level, sets values.

In order to leave the menu without saving value,press [UP] and [DOWN ] at the same time.

After switching on the ArcPower SmartWhite 72 ,the display shows the initial DMX address:

Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].

The fixture can be operated in the two modes:DMX mode-fixture is controlled via DMX 512 by an external

For DMX mode, it is important to define the starting DMX address from which the ArcPower SmartWhite 72

will respond to the DMX controller

Setting the DMX start channel for DMX operating:

1. Connect ArcPower SmartWhite 72 to the mains.

2. Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows current addres

"001".Confirm by pressing [ENTER] button and "001" will start to flash frequently.

3. Use the [UP] and [Down] buttons to select the desired address.

4. Confirm by pressing [ENTER].

After having addressed ArcPower SmartWhite

your DMX controller.

By entering this menu a complete overview of all programs is offered,from which the program to be run can

be selected by pressing [ENTER].Selected program runs in a loop.The fixture includes 2 built-in programs

(P.01,P.02) and one freely editable program (E.P.1) up to 30 steps.

If item "AUt" is On,the fixture remembers last running program and this program will run after switching on the

fixture.

Each program step has a fade time - the time during which effects go to the current step and a Standing time-

-the time,during which effects last in the current step.

DMX controller

Stand-alone mode - fixture uses Built-in programs and is

able to control other fixtures in the master/slave chain.

See the chapter "Stand-alone mode" for detail description.

72,

you may now start operating ArcPower SmartWhite 72 via