Anolis ArcPower 72/K2 사용자 설명서 - 페이지 17

{카테고리_이름} Anolis ArcPower 72/K2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcPower 72/K2 20 페이지.

페이지 인쇄

9.Control of the ArcPower 72/K2 via RS-232

9.1Wiring an RS-232 serial port

9-pin D connector (male)

Front view of the socket:

RS-232 cable:

9-pin D connector- female

ArcPower driver

Pin 1:

Pin : Received Data

Pin 3: Transmited data

Pin 4:

Pin 5: Signal ground

Pin 6:

Pin 7:

Pin 8:

Pin 9:

The maximum cable length according to the standard is 15 metres or the cable length equals to a capacitance

of 500 pF.

9.2 Selecting a zone

The number of the zone distinguishes individual drivers which are controled via RS-3 interface.

Select SPE in main menu of the ArPower 7/K, press [ENTER],use [UP] and [DOWN] buttons to select Zon.

The option enables to select desired number of the zone (from 0 to 8).Press [ENTER],use [UP] and [DOWN]

buttons to select zone number and press [ENTER] to confirm selection.

9.3 Setting a serial port of PC

The serial port of your personal computer hould be configured as follows:

9600 Baud,8 Data Bits,Non Parity,One Stop Bit,No Flow Control Required.

9.4 Zone commands

The ArcPower 7/K uses the 3 types of the zone commands which can be used in a suitable software running

on PC.

All zone commands stated below have to be send to the ArcPower 7/K in ASCII codes.

Type 1: Selection of the preset colours

The syntax of the command is:

zone Z red;

zone Z green;

Pin 1: Not connected

Pin : Received Data

Pin 3: Transmitted Data

Pin 4:

Pin 5: Signal Ground

Pin 6:

Pin 7:

Pin 8:

Pin 9: Not connected

9-pin D connector - female

Pin 1:

Pin : Received Data

Pin 3: Transmited data

Pin 4:

Pin 5: Signal ground

Pin 6:

Pin 7:

Pin 8:

Pin 9: