Dryco Pool Cover Drain Kit 매뉴얼 - 페이지 6

{카테고리_이름} Dryco Pool Cover Drain Kit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dryco Pool Cover Drain Kit 6 페이지.

Installation Instructions for Pool Cover with Dryco

Drain on Above Ground Pools

STEP 1:

Remove the eyeball diverter from the inlet water return

STEP 2:

Separate the union that is attached to the hose and screw

it in the bulkhead. An adapter will be needed for the

bulkhead fittings other than the 1-1/2" female threads.

Assure that the o-ring is installed on the union as shown.

Tighten until o-ring is seated and sealed.

STEP 3:

Before stretching the cover over the pool, connect the

hose with the union to pool inlet. Make sure the o-ring

seal remains seated in the union. Union must have a

watertight seal to prevent loss of any pool water.

Install the cover as normal. Make sure that the drain hose is aligned with the outlet. Twisting the cover may be

required to assure proper alignment.

The hose should drop down toward the bottom of the pool. If the flexible pipe has twisted while being installed, loosen

the union to adjust. The union must be tightened completely to assure a proper seal.