Anolis ArcLine Mini Outdoor 12 사용자 지침

{카테고리_이름} Anolis ArcLine Mini Outdoor 12에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcLine Mini Outdoor 12 3 페이지.

The product generates colored light by means of high power LEDs.The product was designed for interior and

exterior use and it is ideal for locations where signaling,directional or effect lighting is required.

1.Attention

Consider the respective national norms during the installation!

Do not install the unit near naked flames.

Avoid using the unit in locations subject to possible impacts.

Do not attempt to dismantle or modify the unit.

Do not install the module in badly ventilated location

Avoid looking directly into the LED light beam at close range.

2.Installation

The ArcLine Mini Outdoor unit should be connected to the ArcPower 36/72/144/360 or the ArcPower 384 Rack

mount (set at 350mA). See their user manuals for full details of mains power requirements and DMX operation.

For fastening the ArcLine Mini on the wall (flat surface etc) are intended two L-brackets with mountings holes

of diameter of 5 mm each. Adjusting screws on both sides of the ArcLine Mini unit allow to set desired position

in tilt movement.

The ArcLine Mini Outdoor unit can be arranged in any position orientation.

Only one LED module can be connected to the LED output of the ArcPower driver.

If you need to connect more than one LED module to the ArcPower driver, you have to use the ArcLine Mini

Outdoor IN/OUT version. The last LED module has to be this standard ArcLine Mini Outdoor - see the ArcLine

Mini Outdoor IN/OUT user manual. Do not overload LED output of the ArcPower driver.

3.Connections

1. ArcLine Mini Outdoor

User instructions

ArcLine Mini Outdoor 9/12/18/27/36