Dryflow DFLIF02 사용자 설명서 - 페이지 5

{카테고리_이름} Dryflow DFLIF02에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dryflow DFLIF02 12 페이지.

INSTALLATION

1. Be sure to turn off the electric supply before any operation.

2. Place template against wall at desired height (see mounting height recommendations)

and mark locations of 4 mounting holes Dia. 8mm(5/16").

3. Remove hand dryer back transportation only purpose screw.

4. Remove and retain 2 side security hex cover screws and cover.

5. Mount the hand dryer base on the wall.

6. If the hand dryer is supplied in hardwired:

a. Connect the live wire(Coloured Brown, Red, or Black) to the terminal block marked "L".

b. Connect the neutral wire(Coloured Black, Blue) to the terminal block marked "N".

c. Connect the ground wire(Coloured Green or Yellow) to the terminal block marked "E".

7. Before replacing cover, there is a customized option to run the dryer heater on (1000W) or

heater off(600W).The switch is clearly marked.

8. Default setting is 12-15CM from nozzle. If it needs and please adjust its range.

9. Replace cover. Do not over-tighten screws.