Dryflow Jet Force Junior 사용자 설명서 - 페이지 10

{카테고리_이름} Dryflow Jet Force Junior에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dryflow Jet Force Junior 12 페이지.

Replace Display Circuit Board

1. Move the sticker away. Do not damage the hand dryer edge as it will affect the surface appearance.

2. Move two screws on timer circuit board holder. Use a screwdriver to pull the holder a little to open it.

3. Take holder out and circuit board will come together. Be careful of the connection wire.

4. Move two screws on circuit board and replace a new one.

5. Replacing new circuit board. It is suggested to use a new sticker for best appearance.

Open Hand Dryer Front Cover

1. Loosen 4 front cover screws on hand dryer back base as the arrow marked.

2. Loosen 2 front cover screws on the hand dryer front & bottom.

3. Pull the front cover up then back a little to take it.

4. Pull the cover slowly and slightly because there are plastic locks on the top side.

5. DO NOT damage the top side plastic locks because they are used to fix the front cover on

the base.

4 front

cover screw

2 front cover screw

Display circuit board

Plastic locks