Anova F1146 조립 지침 - 페이지 2
{카테고리_이름} Anova F1146에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Anova F1146 2 페이지.
페이지 인쇄
6. Install the remaining Table Top Supports in the same manner.
7. Locate the Rubber Feet and install one
in each of the two outside holes on
the bottom of each of the Table Top
Supports.
Use the Rubber Mallet to set them if
necessary.
8. Locate the Cross Brace and position it in the center of the Table Top Supports so that the mounting holes in the Brace line up
with the mounting holes in the Supports.
Place a Flat Washer on the end of one of the 2.50" long Screws and insert the Screw through the Table Top Support mounting
hole and through the matching hole in the Cross Brace.
Fasten the Screw using a Flat
Washer and Flanged Nut. Leave the
Nut finger tight.
Repeat this for the remaining Cross
Brace mounting holes.
9. Turn the table Right side up.
10. Level the Table Top while tightening all of the hardware.
11. Move the Table to the location where it will be used.
12. After two weeks, retighten all hardware.
•
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
missing, or broken hardware, and general instability.
•
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
wArnInG
•
Repairs must be made using only factory authorized parts and methods.
cAre AnD
•
Do not drag the assembled unit across any surface.
mAIntenAnce
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
remove surface dirt. Do not clean with a solvent or petroleum based products.
211 No
St. Louis, MO 63141
Install Rubber Feet in
the two outside holes
Flanged Nut
Flat Washer
rth Lindbergh Blvd.
Flanged Nut
Flat Washer
Cross Brace
Flat Washer
2.50" Long Screw
tel: 888.535.5005
web: anovafurnishings.com
Flanged Nut
Flat Washer
1.25" Bolt
Flat Washer
2.50" Long
Screw
Flat Washer
Table Top
Support
10/2012