Drytac HOT PRESS HGP260 운영자 매뉴얼 - 페이지 14

{카테고리_이름} Drytac HOT PRESS HGP260에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drytac HOT PRESS HGP260 19 페이지. Heated glass top vacuum press
Drytac HOT PRESS HGP260에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

Your actual settings will vary according to the size of the press, type of dry mounting tissue, type of

mounting substrate, the artwork material used (in terms of material and the size of the print. See

specific product specifications for recommended dwell times (dwell times provided are for paper

graphics).

1. Cut a piece of ArtShield™ UV HeatSet laminating film (or other appropriate heat activated

laminating film) approximately ½" (1cm) larger (on all sides) than the print to be laminated. At

this stage, your print may already be mounted or, ifyou choose, you may dry mount at a later

time without affecting the laminated finish (refer to step 8 below).

2. If the print/graphic to be laminated has a non-breathable surface such as a resin coated (RC)

photograph, it will be necessary to sue a pre-perforated ArtShield laminating film.

selected film is not pre-perforated, place it onto a cutting mat or card stock with the film surface

face up. Using a perforating tool, lightly pierce the film in a crisscross pattern; ensuring the

holes are approximately ¼" (6mm) apart.

3. A release paper backing protects the adhesive coated side of the laminating film. Peel this

back approximately 1" (2.5cm), exposing one edge of the laminating film. Place your print face

up on a clean work surface. Position your laminate on top, exposed adhesive edge down.

While holding it firmly on the table with one hand, gently pull the release paper away and

toward you from underneath.

4. Check that there is no dirt or dust trapped under the laminating film. If necessary, the film may

be gently lifted, the contaminants removed and the film repositioned.

5. Using a burnishing pad or soft cloth, lightly smooth the laminating film down onto the print to

remove excess air bubbles.

6. Place the print onto a larger piece of silicone release paper/film shiny side up.

7. Preheat your press to 180-210° F (82-99° C)*.

8. Cover your work with the foam overlay blanket and place into the press.

9. Your work piece should be processed for two to ten minutes* - beginning from the time that the

press has achieved the desired pressure setting.

10. The final result should be a blemish-free finish. If any silvering is apparent under the clear film

(especially visible in the dark areas), re-insert and process for an additional 2-10 minutes*.

Caution:

ArtShield

Glossy laminating film cannot be pierced and is not recommended for

™

photographs.

Illustration 12B: Applying Artshield laminate

to the print/photo.

If the