Drytac HOT PRESS HGP260 운영자 매뉴얼 - 페이지 7

{카테고리_이름} Drytac HOT PRESS HGP260에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drytac HOT PRESS HGP260 19 페이지. Heated glass top vacuum press
Drytac HOT PRESS HGP260에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

crate onto the stand. Align the press with the ends of the

raise lid. Remove three screws at front of diaphragm and draw diaphragm forward by

approximately 300 mm or 12 inches. Working from the underside of the diaphragm, remove the

hose(s) from the ﬁttings in the corners of the diaphragm by pushing the collar on the ﬁttings

inwards while pulling out on the hose. Remove the diaphragm from press. Using the 4 M6 x 80 mm

bolts, 8 M6 penny washers, 4 M6 spring washers and 4 M6 nuts, secure the press to the stand by

passing the bolts up through the holes in the stand ends and into the base of the press. Tighten

these nuts and bolts. Insert the diaphragm back into the press and insert the hoses back into the

ﬁttings on the underside of the diaphragm.

Push the diaphragm back into position ensuring it ﬁts into the three clips at the back of the press

and re-ﬁt the three screws at the front of the diaphragm.

Stand Assembly Instructions for Small Models (HGP220 / 260/ 360)

Component list:

•

2 x leg assemblies

•

2 x top rails

•

2 x bottom rails

•

12 x rail bolts (16 x for 360) M8 x 60 mm dome head

•

4 x press ﬁxing bolts M6 x 80 mm cap head

•

4 x penny washers ¼ x 1 "

•

4 x lock washers M6

•

1 x M6 Allen key

Loosely ﬁt the top rails to the top of the leg assemblies to form a rectangle, using 8 of the M8 x 60

mm bolts. Loosely ﬁt the bottom rails, about half way up the leg assemblies, using the remaining

M8 x 60 bolts. Tighten all bolts using the Allen key and ensure stand is steady. The top rails are

inset from the front and rear, the largest inset is the front of the stand. Lift press onto stand. Fit M6

x 80 mm bolts with lock washers, then with the penny washers, then insert them up through the leg

assemblies into the base of the press. Tighten the bolts (using the Allen key) until rubber press feet

are compressed slightly.

CONNECTING THE VACUUM PUMP

A length of plastic vacuum tubing (either red or green,

depending on the model) is supplied with the equipment.

Connect one end to the pump and the other end to the rear

of the vacuum press. No tools are needed - the tubing is a

simple "push ﬁt" into the special connectors. You will feel

stand. Undo catches at front of press and