Anova F1300 조립 지침 - 페이지 3

{카테고리_이름} Anova F1300에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Anova F1300 3 페이지. 6' picnic table
Anova F1300에 대해서도 마찬가지입니다: 조립 및 사용 설명서 (2 페이지)

10.

Locate the table top supports and position them on opposite sides of the in ground support, in the proper orientation. Align

the mounting holes in the table top supports with those in the in ground support. Place one of the 1/2" flat washers on one of

the 7 1/2" hex head bolts and insert the bolt through both table top supports and the in ground support mounting holes. Place

a 1/2" flat washer and 1/2" nylock nut to the end of the bolt and tighten finger tight. Repeat for the other three mounting

holes. After all bolts are installed, use the ratchet with 3/4" socket and the 3/4" open or box-end wrench to tighten the nuts.

1/2" Flat Washer

1/2" - 13 x 7 1/2" Hex Head Bolt

Table Top Support

Locate the table top and carefully place it on top of the table top supports. Place one of the 5/16" flat washers on one of the 1

11.

1/4" hex head bolts and insert the bolt through the mounting holes in the table top support and table top frame. Place one of

the 5/16" flat washers and 5/16" nylock nuts to the end of the bolt and tighten finger tight.

Repeat for the other mounting hole in that end of the table top. Fasten the other end of the table top to the other table top

support in the same manner.

After all bolts are installed, use the ratchet with 1/2" socket and the 1/2" open or box-end wrench to tighten the nuts. Check

with a level and adjust the table top as needed while tightening.

12.

Retighten all of the hardware two weeks after initial assembly.

Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.

Assembly and Replacement Parts

01/30/2018

1/2" Flat Washer

1/2" - 13 Nylock Nut

Tabletop

5/16" - 18 x 1 1/4"Hex Head Bolt

5/16" Flat Washer

5/16" - 18 Nylock Nut

Table Top Support

Tabletop

Tabletop Supports

Seats

Seat Supports

In Ground Support

Made in USA.