Drytac HOT PRESS HGP560 사용자 설명서 - 페이지 3

{카테고리_이름} Drytac HOT PRESS HGP560에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Drytac HOT PRESS HGP560 19 페이지. Heated glass top vacuum press
Drytac HOT PRESS HGP560에 대해서도 마찬가지입니다: 운영자 매뉴얼 (19 페이지)

페이지 인쇄

HOT PRESS USERS MANUAL

Safety Considerations

This product should only be used for the purpose and manner for

which it was designed. Before installing and using the equipment,

please read this entire manual and be sure that you understand

all the aspects of proper use. Some of the more important safety

considerations are listed below.

• Ideally, the vacuum press should be used with a metal stand

(available from Drytac). If a stand is not used, the press

must be located on a sturdy table or countertop capable of

supporting its weight (refer to Technical Speciﬁ cations on page

17 of this manual). The largest model (HGP560) is supplied

with a stand, which must be used due to the weight of the unit.

• Connection of the equipment to the power source must be

handled by a qualiﬁ ed electrician familiar with local and

national electrical codes. It is mandatory that the equipment be

properly grounded.

• The gas struts which support the lid are a critical safety item.

They must be fully extended (in other words, the lid must be

open completely) in order for them to support the weight of the

lid. The press must be installed in a location which allows the

lid to be completely raised without interference. If the lid is only

partially opened, it may close unexpectedly.

• Before each use, the struts should be checked to be sure they

are operating properly. Over a period of time, the struts will

lose pressure and will eventually require replacement.

• The inner surface of the glass top is very hot during normal

operation. Be very careful not to touch the glass when

inserting or removing materials from the press.

• Before servicing the equipment, it must be disconnected from

the power source.

• If either of the circuit breakers on the rear panel of the unit

should trip repeatedly, unplug the equipment and have it

serviced. The same applies to the fuses on the side panel.

• The vacuum press incorporates a high-temperature safety

cutout device, which disconnects all power from the unit if the

internal temperature reaches a predetermined level (257°F

/ 125°C). If the unit unexpectedly shuts off during use and

later comes back on after cooling down, it is likely that this

safety device has activated. This indicates a problem with the

temperature control system, and the unit should be repaired by

a qualiﬁ ed technician.

• Do not use a knife to cut materials while they are inside the

press. This could cause damage to the diaphragm.

Safety