Anova MG3514 지침 및 사용 설명서 - 페이지 14

{카테고리_이름} Anova MG3514에 대한 지침 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anova MG3514 19 페이지.

10.2. The sword

When disassembling the guide bar, remove the sawdust in the groove of the bar and

the grease inlet. Grease the bar sprocket.

Check for fuel leaks and loose fasteners and damage to major parts, especially

handle joints and guide rod mounting. If any defects are found, make sure they are

repaired before using again.

10.4. Plugs -Clean the electrodes with a wire brush and adjust the 0.65mm gap as needed.

10.5 MAINTENANCE OF THE CHAIN AND THE BAR (SHARPENING)

It is very important to keep the chain and the cutting bar in the best cutting conditions and

properly sharpened. Sharpen the chain when the following occurs:

The chip turns into a fine powder.

You need to push and force the chainsaw to cut.

The cut is not straight.

Increase the vibration.

Increase fuel consumption.

Use an appropriate file for sharpening the chain on the machine.

Chain: 3/8LP .050

File diameter: 4.0 mm

Place the file on the tooth and press straight forward. Hold the position as shown in the

image.

After each cut, check the depth of the cutting guides and back off as also seen in the

picture.

Be sure to round off the end of the guide to prevent kickback or chain

breakage.

It is important that each cutting tooth is the same length. And the

angles also follow the same measurement as shown in the image.

1. Guide depth gauge.

2. Make sure the guide is rounded.

3. Reference Guide Depth

4. cutting tooth length

5. Side cutting angle

6. top cutting angle

10.3. cylinder fins

Dust clogging between the cylinder fins will cause the engine to overheat.

Periodically check the fins after removing the clutch cover, and then use

compressed air to clean the cylinder fins.